Our Brand PH Aluminum 1 Inch One Touch Cordless

Priced as low as

Based upon a size of 24x36

Completely cordless 7 gauge aluminum blinds. One touch raising and lowering. One touch tilting. To lower blind: Grip the Bottom-Rail/Handle and slowly pull straight down. To raise blind: Put one hand under the Bottom Rail (palm facing up) and lift with a slow steady tempo until the desired height is reached. To tilt the slats: Lower and raise the handle slowly. This is a learned technique, but takes only a few seconds to master.

Priced as low as

Based upon a size of 24x36


1 inch New Cordless Aluminum Budget


Check Here Before Ordering Click here for New cordless Specifications!

Black View Larger
Bone View Larger
Brown View Larger
Brushed Aluminum View Larger
Brushed Bronze View Larger
Mocha View Larger
Beige View Larger
White View Larger

Tips To Remember:

Use a steel measuring tape
Round down to the nearest 1/8" for width
Round up to the nearest 1/8" for height
See Product Specifications for more specific product info.
Sizes should always be provided in this format: Width x Height
On any measurement given, the factory does have a +/- 1/8 of an inch variance    allowance.

Measure For Aluminum Blinds.

Inside Mount Width

•    Measure the exact width (left to right) of the inside edge of the window frame in three places (top, middle and bottom).
•    Take the smallest of the three measurements to the nearest 1/8 of an inch.
•    The factory will take an approximate 1/2 of an inch deduction from the total width to a lot for brackets and correct installation.

Inside Mount Height

•    Measure the exact height (top to bottom) from the top inside edge down to the window sill in three spots across window.
•    Take the largest of the three measurements.

Outside Mount Width

•    Measure the exact width (left to right) of the wooden or metal window frame (outer edge) OR how wide you want the product to be.
•    Be sure to measure wide enough as to cover the entire window plus offer enough coverage to avoid light or privacy gap. 2 inches past the opening on EACH side is suggested if you do not have molding/trim.
•    An Outside Valance with returns will be wider than the ordered width to accommodate covering the headrail and mount.

Outside Mount Height

•    Measure the top and bottom edge of window frame/trim. If no trim, be sure you provide the height you want the shade to be from top of the headrail to bottom of the bottom rail.
•    Be sure to allot for coverage for light control and mounting hardware if mounting above window opening to wall surface. You will need 2 inches of surface area to mount above opening. Call us for further instruction if needed.

  Aluminum Blind Installation Instructions