Our Brand 2 inch Wood Blinds are real Hardwood Blinds that come in many different colors and stains. These blinds are the best deal on the internet made by a major manufacturer, but without the expensive advertising label.
Based upon a size of 24x36
This product is normally shipped within 2-3 business days if in stock. PLEASE NOTE: Our Brand 2" Wood Blinds are only available with Center Tilt (no lift) if smaller than 11 inches width. Please choose Center Tilt if the width is smaller than 11 inches to avoid delaying your order.
General Specification Information – Applies to all wood product lines
Tips To Remember:
Use a steel measuring tape
Round down to the nearest 1/8" for width
Round up to the nearest 1/8" for height
See Product Specifications for more specific product info.
Sizes should always be provided in this format: Width x Height
On any measurement given, the factory does have a +/- 1/8 of an inch variance allowance.
Measure For Wood or Faux Wood Blinds
Inside Mount Width
• Measure the exact width (left to right) of the inside edge of the window frame in three places (top, middle and bottom).
• Take the smallest of the three measurements to the nearest 1/8 of an inch.
• The factory will take an approximate 1/2 of an inch deduction from the total width to a lot for brackets and correct installation.
Inside Mount Height
• Measure the exact height (top to bottom) from the top inside edge down to the window sill in three spots across window.
• Take the largest of the three measurements.
Outside Mount Width
• Measure the exact width (left to right) of the wooden or metal window frame (outer edge) OR how wide you want the product to be.
• Be sure to measure wide enough as to cover the entire window plus offer enough coverage to avoid light or privacy gap. 2 inches past the opening on EACH side is suggested if you do not have molding/trim.
• An Outside Valance with returns will be wider than the ordered width to accommodate covering the headrail and mount.
Outside Mount Height
• Measure the top and bottom edge of window frame/trim. If no trim, be sure you provide the height you want the shade to be from top of the headrail to bottom of the bottom rail.
• Be sure to allot for coverage for light control and mounting hardware if mounting above window opening to wall surface. You will need 2 inches of surface area to mount above opening. Call us for further instruction if needed.
Installation instruction-Details for Standard Valance Clips........Details for Magnet Valance clips